EXPERIMENTAL: Cupcakes with Gen 3 electronics: A 3G5D Shield or the 'Ugly Cable Hack' is required in order to control a stepper-based extruder.Cupcakes with Gen 4 electronics: As per the above.Other electronics and extruders may or may not work with the Sailfish firmware. Stepper-based extruders include the Mk6, Mk6+, Mk7, and Mk8. Other than the extruder, these are all 'stock' Thing-o-Matic electronics i.e., Gen 4 electronics. Thing-o-Matics: a Makerbot v2.X motherboard, a Makerbot v3.6 Extruder Controller, Makerbot v3.3 Stepper Drivers, a stepper-based extruder, and an Arduino Mega or Arduino Mega 2560.Replicator 1s: Makerbot MightyBoard revE or later electronics with one or two extruders.

For Replicators, single and dual extrusion is supported. The Sailfish firmware described here runs on MightyBoard, Gen 4 and Gen 3 electronics. Use of 'ReplicatorG 40' or 'ReplicatorG 40 - Sailfish' is not recommended with one exception: to enable 'Extruder Hold' for bots with 3mm filament extruders. This version of Sailfish may be obtained at Thing 32084. Sailfish requires use of 'ReplicatorG 39 - Sailfish' or later. For versions prior to v4.0, please see Jetty Firmware - Setup Guide. This document provides directions on how to install versions 4.0 and later of Sailfish Firmware on a Replicator 1, Thing-o-Matic, Cupcake, or other RepRaps using either Gen 4 or Gen 3 electronics.

REPLIKATOR instaling